Köpes: Mb6/Mc2 delar
-
Peggen
- Inlägg: 204
- Blev medlem: 15 februari 2010, 14:55
- Bil: Honda Accord Type-R
- Namn: Henrik Holmgren
- Ort: Mariestad
- Has thanked: 2 times
- Been thanked: 3 times
Någon som har:
Orginal fjäderbensats runtom liggande eller bättre coilovers?
Insynsskydd/rullgardin?
Bagagerumsmatta (plast)
Centrallås dosa?
Orginal fjäderbensats runtom liggande eller bättre coilovers?
Insynsskydd/rullgardin?
Bagagerumsmatta (plast)
Centrallås dosa?
[font=Bradley Hand ITC]Peggen[/font]
- oskar

- Inlägg: 2837
- Blev medlem: 28 april 2004, 01:22
- Bil: Crx 1.6i-VT på Steroider
- Namn: Oskar Johansson
- Ort: Romelanda (Kungälv)
- Has thanked: 127 times
- Been thanked: 52 times
Hej
Om inte jag minns fel körde jag med EK fjäderben med en extra distans bak på min MC2.
Om inte jag minns fel körde jag med EK fjäderben med en extra distans bak på min MC2.
Oskar Johansson
Vice ordförande Hondaklubben
*0733-124451*
Honda Accord Type R 2002
CRX 1.6-i VT 1991
Civic 1.8i 1989
Hondaklubben Kungälv medlem #936
0733-124451
Kinnekulle 1:02:73
Gelleråsen 1:21:38
Anderstorp 2:01:xx snigelfart jag vet....
Vice ordförande Hondaklubben
*0733-124451*
Honda Accord Type R 2002
CRX 1.6-i VT 1991
Civic 1.8i 1989
Hondaklubben Kungälv medlem #936
0733-124451
Kinnekulle 1:02:73
Gelleråsen 1:21:38
Anderstorp 2:01:xx snigelfart jag vet....
-
Peggen
- Inlägg: 204
- Blev medlem: 15 februari 2010, 14:55
- Bil: Honda Accord Type-R
- Namn: Henrik Holmgren
- Ort: Mariestad
- Has thanked: 2 times
- Been thanked: 3 times
Hejsan.
Så Ek3 fjäderben passar alltså till Vtin, vad för extra distans?
Vilket reg nummer på Mc2an hade du?
Mvh
Så Ek3 fjäderben passar alltså till Vtin, vad för extra distans?
Vilket reg nummer på Mc2an hade du?
Mvh
[font=Bradley Hand ITC]Peggen[/font]
- Lärfors

- Inlägg: 2355
- Blev medlem: 14 juli 2015, 21:03
- Bil: 89 Civic Shuttle (EE2)
- Namn: Andreas Lärfors
- Ort: Göteborg
- Has thanked: 450 times
- Been thanked: 305 times
Vad är du ute efter? Ska du bara sänka bilen lite eller ska du köra bana?
Vad har du för budget?
Lite sökningar både här på forumet och Google:
viewtopic.php?f=5&t=74749&p=736436&hilit=mb6#p736436
https://civic5.com/forum/topic/1260-is- ... s-the-mc2/
Vad har du för budget?
Lite sökningar både här på forumet och Google:
viewtopic.php?f=5&t=74749&p=736436&hilit=mb6#p736436
https://civic5.com/forum/topic/1260-is- ... s-the-mc2/
https://civic5.com/forum/topic/1877-eg- ... on-on-mb6/Is MB6 suspension springs and struts the same as the MC2?
Hey, yes they are the same only difference between the two cars suspension wise is that the MC2 has no anti roll bar on the rear.
Struts, springs etc are the same.
EK Coilovers can fit MB6.
The front is the same as the EG / EK. The rear have the same fork size as the EK (40mm).
However, because the MB6 standard rear suspension are longer than the EK, the range of height adjustment will not be correct.
if you get a set EK coilovers, you won't have any room to play with them.
As most likely the highest point of adjustment will only be where it is acceptable on the MB6.
You can get away a little using a Dual Perch Coilovers like MeisterR Zeta-S as you can adjust the ride height and the spring pre-load...
On a single perch coilovers such as Tein Super Street... it will mean the rear springs will have be need to have massive amount of pre-load in them just to keep the ride height to what you need.
In the end, it depends on what you are looking for.
If you are looking for cheap drop, then the EK coilovers will "fit"; but it doesn't mean it will be "right" on the MB6.
Andreas Lärfors : IT ansvarig
-
Peggen
- Inlägg: 204
- Blev medlem: 15 februari 2010, 14:55
- Bil: Honda Accord Type-R
- Namn: Henrik Holmgren
- Ort: Mariestad
- Has thanked: 2 times
- Been thanked: 3 times
Jag är ute efter orginal fjädring/höjd på bilen. Det sitter ett par helt slut/stumma TA coilovers på den som måste bort.
Lite säkning vore ju fint 2-4cm.
Lite säkning vore ju fint 2-4cm.
[font=Bradley Hand ITC]Peggen[/font]
- Lärfors

- Inlägg: 2355
- Blev medlem: 14 juli 2015, 21:03
- Bil: 89 Civic Shuttle (EE2)
- Namn: Andreas Lärfors
- Ort: Göteborg
- Has thanked: 450 times
- Been thanked: 305 times
Nu kanske jag svär lite i kyrkan men vill du komma billigt undan beställer du ju nya dämpare och (sänk)fjädrar från t.ex. Autodoc:
Dämpare:
https://www.autodoc.se/ridex/8002617
Fjäder: (fram)
https://www.autodoc.se/ridex/8262372
Sänkfjädrar:
https://www.autodoc.se/eibach/7431489
Dämpare:
https://www.autodoc.se/ridex/8002617
Fjäder: (fram)
https://www.autodoc.se/ridex/8262372
Sänkfjädrar:
https://www.autodoc.se/eibach/7431489
Andreas Lärfors : IT ansvarig