Hur byta blinkers i backspegel CTR-04

[Oscar.Y]

Om någon vet hur man tar sig in i backspegeln på en CTR för att byta blinkers/diodpaket så skulle det uppskattas!

Var inne på Honda men tydligen så prioterar dom inte kundbemötande så deras svar var
"du kan väl ta bort backspegeln och lämna den här så kan vi pilla lite och se hur man gör,då kan du ju iallafall åka med bilen under tiden"

Vad i hel****, jo jag vill ju gärna åka omkring i "soliga" sverige med silvertejp på bilen alternativt fukt innanför dörrsidan...Nice

Hursomhelst om nån har en sprängskiss eller har genomfört en blinkerstransplantation så uppskattar jag alla förslag.

FYI dom ville ha 700-800:- för jobbet!

Tack på förhand!

Oscar

[Krister]

Ring Rosenholtz och kolla... Sveriges förmodligen mest uppskattade Hondahandlare.

[Forenademotor.se]

Så här beskrivs det i WSM

Lower the door glass fully.
Carefully pry out the mirror mount cover (A) by hand in the sequence shown.
Remove the door panel.

--------------------------------------------------------------------------------
If equipped with a tweeter, pull the plastic cover (A) back as necessary, and disconnect the connector (B), then remove the mirror mount cover © with the tweeter.
Disconnect the connector (D).
While holding the mirror, remove the nuts securing the mirror.

--------------------------------------------------------------------------------
While holding the mirror, push out the connector clip (A), and remove the mirror (B). Take care not to scratch the door.
Install the mirror in the reverse order of removal, and make sure the connector is plugged in pr

Remove the mirror holder and disconnect the mirror defogger connectors*.
*: With defogger
Remove the power mirror.
Disconnect the 6P connector (A) from the mirror, and record the terminal locations and wire colors.
Cut the wire harness with cutter, and remove the gasket.

--------------------------------------------------------------------------------
Remove the three screws from under the mirror.

--------------------------------------------------------------------------------
Remove the three Torx screws using a Torx T10 bit, then remove the actuator (A).

--------------------------------------------------------------------------------
Installation :
Route the wire harness (A) of the new actuator through the hole in the bracket.

--------------------------------------------------------------------------------
Insert the terminal into the connector as shown below :
Seal the intersection of wire harness with tape.
Reassemble in the reverse order of disassembly.Be careful not to break the mirror when reinstalling in to the actuator.
Reinstall the mirror assembly onto the door.
Operate the power mirror to ensure smooth operation.

--------------------------------------------------------------------------------
3/5-door
Remove the power mirror actuator.
Disconnect 2P connector (B) from the side turn signal light
Install in the reverse order of removal.